...
Notification Recipients: A list of phone numbers that are to receive the message. Note that all numbers configured in the base configuration will receive the message as configured there. Only phone numbers listed in specific extensions will receive the message as configured by that extension.
Reboot router by SMS
This action sends up to two SMS to a mobile router with a short delay in between. A properly configured router that supports triggering hooks through SMS messages can be hard-rebooted this way, and the connected camera controller right along with it.
This action is a bit special as it only has an effect if it gets extended in a specific camera alarm configuration. This is due to the fact that the camera of each router will have its individual phone number, and setting any kind of useful default for that is impossible.
...
Router number: The phone number of the routers sim card. It must contain a country code, and may contain only numbers apart from the initial +. This field is only available when extending the config for a specific camera, but there is required.
Commands: Up to two messages will be sent with a small delay to each other. Here you can specify the text body of those two messages, which, for these purposes, will usually be a short keyword, mostly depending how you or your supplier configures their routers and the routers being used. In general, these should be configured in the base configuration and left untouched in any extensions, but you may have the odd package that requires a different command or set of commands.