Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Current »

The PoE/ PoE+ injector has been developed for the voltage supply of PoE-devices. The PoE/PoE+ injector supports the standards 802.3af and 802.3 at. A crucial benefit of the PoE/PoE+ injector is the wide input voltage range of 5-36 VDC. The PoE injector is ideally suited for running cameras.  Due to the low input voltage it is also suitable for operations by solar power.

Pictures: PoE/PoE+ injector

Important

Use the Passive PoE Injector if the photo webcam is used with a front glass defroster heater.


Picture: Plug PoE/PoE+ Injector

Plug/ JumperPinFunction
P11Input voltage 5-36VDC / 48-56VDC

2Ground GND

3Digital output
VDC if a PoE-device is connected
GND if no PoE-device is connected

4Deactivates PoE output if Ground GND is applied

5Deactivates PoE output if VDC is applied
J1RJ45Ethernet towards Internet

RJ45Ethernet plus PoE/PoE+ output towards camera
JP1 + JP2

Configuration input voltage

JP3
Output voltage

Specifications

FunctionDescription
Input voltage

5-36VDC / 30W

Output802.3af 48VDC 15.4W or 802.3at 56VDC 25.5W configurable
Ethernet10/100/1000Base-T
Digital Inputschaltet PoE+ Ausgang ein/aus, pull-up/pull-down, VDC Eingangsspannung
Digital OutputMonitorsignal zur Kontrolle, ob POE+ Verbraucher angeschlossen, open Collector
Operating temperature-40°C to +75°C / -40°F to 167°F
Dimensions (LxWxH)12 x 9.5 x 3.8 cm
AssemblyDIN rail optional

Documents

poe_injector_datasheet_1704.pdf

PoE_injector_V2_1.pdf

  • No labels

0 Comments

You are not logged in. Any changes you make will be marked as anonymous. You may want to Log In if you already have an account.